Podaci o nacrtu

Oznaka:prEN ISO 11961
Odbor:HZN/TO 506
Ime odbora:Materijali, oprema i konstrukcije za naftnu industriju, prirodni plin i geotermalnu vodu
Nacrt objavljen za komentiranje:2017-09-20
Rok za komentiranje:2017-10-21
Broj komentara:0
Contact email:nacrti(at)hzn.hr
Područje primjene nacrta:

This International Standard specifies the technical delivery conditions for steel drill-pipes with upset pipe-body ends and weld-on tool joints for use in drilling and production operations in petroleum and natural gas industries for three product specification levels (PSL-1, PSL-2 and PSL-3). The requirements for PSL-1 form the basis of this International Standard. The requirements that define different levels of standard technical requirements for PSL-2 and PSL-3 are in Annex G.

This International Standard covers the following grades of drill-pipe:

grade E drill-pipe;

high-strength grades of drill-pipe, grades X, G and S;

enhanced H2S resistance drill pipe, grades D and F.

A typical drill-pipe configuration is given, showing main elements and lengths (see Figure B.1). The main dimensions and masses of the grades of drill-pipe are given in both SI units (see Table A.1) and in USC units (see Table C.1).

This International Standard can also be used for drill-pipe with tool joints not specified by ISO or API standards.

By agreement between purchaser and manufacturer, this International Standard can also be applied to other drill-pipe body and/or tool-joint dimensions. This International Standard lists supplementary requirements that can optionally be agreed between purchaser and manufacturer, for testing, performance verification andnon-destructive examination (see Annex E).

This International Standard does not consider performance properties, nor performance degradation of the product when in service.

NOTE 1       In this International Standard, drill-pipe is designated by label 1, label 2, grade of material (E, X, G, S, D and F), upset type and type of rotary shouldered connection. Designations are used for the purpose of identification in ordering.

NOTE 2       Reference can be made to ISO 10424-2 or API Spec 7-2 for the detailed requirements for the threading of drill-pipe tool joints.

NOTE 3       Reference can be made to API RP 7G for the performance properties of the drill-pipe.

Sustav komentiranja nacrta norma – Sufinancirale Europska unija i EFTA    

HZN snosi isključivu odgovornost za ovu aplikaciju. Europska unija ne odgovara za upotrebu informacija koje su u njoj sadržane.